Brookhaven, PA

.

Upon arrival for maintenance on gas furnace I changed air filter. I cleaned the flame sensor. I inspected heat exchanger and burners. I checked blower motor and assembly. I checked the resistance of igniter. Checked all wiring and control board. I checked inducer operation and ensured hose port was clear. I checked gas pressures. Checked air temperature rise. Performed combustion test. Unit is in normal operation at this time.

Upon arrival for maintenance on gas furnace I changed air filter. I cleaned the flame sensor. I inspected heat exchanger and burners. I checked blower motor and assembly. I checked the resistance of igniter. Checked all wiring and control board. I checked inducer operation and ensured hose port was clear. I checked gas pressures. Checked air temperature rise. Performed combustion test. Unit is in normal operation at this time. Fixed customers filter door. Wasn’t screwed into wall all the way and grill was hitting enclosure. Changed batteries in tstat and water alarm customer provided.

Changed filter, checked electrical, checked delta t, checked condensate pump, tested condensate pump, checked contactor, checked capacitor, checked pressures.

Checked the a/c side of the system. Checked the air filter and replaced . Inspected the wiring connections and the voltages. Inspected the indoor coil and flushed and tested the coil pan and the condensate drain line . Checked the blower motor condition and checked static pressure and amp draws . Checked the outdoor unit pressures by using super heat and sub cool methods. Inspected the capacitor and checked the amperage for the fan motor and the compressor. Checked the indoor cooling splits at the return and the supply. The a/c system is working fine at this time of service.

Completed AC tune up for 2.5 ton Amana AC system: 16x25x1 filter in good condition. Inspected condition of both the indoor and outdoor coil Measured temperature split (68-45=23°Good) and static pressure Ensured drain and EZ trap are clear Inspected wiring, controls, electric motors and components including fan speed. Verified integrity of compressor motors using megaohmeter. Reminder If REME Cell was installed June 2023 it is due for replacement June 2025. Monitored R410A refrigerant pressures and diagnostics: Good System is operating well at this time. Homeowner paid for plan membership today.

Customer was just looking for information. He’s going to replace his chimney vented, gas water heater by himself.

Estimate

Completed plan member heat tune up for 100,000BTU natural gas furnace 80% Efficiency Replaced 16x25x1 filter Inspected and burners, heat exchanger rusty Inspected standing pilot assembly Inspected wiring, controls, electric motors and components Confirmed proper manifold gas pressures; Measured temperature rise and static pressure temp rise is high and unit periodically goes off on high limit. Inspected all components of drain Combustion, smoke and draft tests: Pass Would consider upgrading HVAC system. Furnace is operating well at the time of this tune up.